Pressure Wash Your House - Tips and Techniques

Pressure or pressure washer is the only practical way to remove mud and mold from your home

Article Card image

Pressure or pressure washer is the only practical way to remove mud and mold from your home. To get the most out of a painting job, you also want to wash your home. This gives the paint a good, clean surface to adhere to. Although the term is pressure washing, you do not really use a lot of pressure when it comes to lining your home. Only low pressure is used, approx. 300 psi. Some contractors ignore this and will try to use high pressure and it can be very dangerous as it is likely to cause damage. Before hiring a contractor, this should be your first question.

Almost all coating material can benefit from pressure washing Jacksonville. The sturdy plank, brick, vinyl siding and aluminum will benefit from good cleaning from time to time. Care must be taken when cleaning soft materials such as wood, but if low pressure techniques are used, there may be some damage. Cleaners must be applied according to the type of material from which their exterior is made. For most materials, a combination of bleach and household cleaner is sufficient. For wood, use a special detergent that lights up the wood and does not remove color. All necessary cleaning materials can be found in your local hardware store.

For a high-pressure cleaning job, do it yourself, you can get a unit in a rental equipment. The cost is about $ 50 per day. It is not necessary to get a heavy device as it uses low pressure to clean the house. A unit of up to 1500 psi is all you need. Although the unit can withstand 1500 psi, you will have a house sink tip that reduces pressure. This is achieved by using a tip with a larger aperture that reduces pressure and allows more volume to flow through the hole.

High-pressure cleaners have a 'downstream' function that absorbs the detergent and mixes it with water as it flows through the unit. Generally, a 5 gallon bucket will be filled with the necessary detergent or bleach and a small hose connected to the unit will be placed in the bucket. As the water begins to flow through the system, a suction is developed that draws the cleaning product and sprays it with the water in a proportion of 1-5 to 1-7.

If you use bleach to clean mold and mold, add a 100% bleach solution to the bucket. For other cleaning products, read the instructions. Be sure to remove anything from the house that may be damaged by the bleach. A quick rinse of flowers and shrubs is usually all that is needed to ensure that plants are not suffering.

The best way to really clean your house is to start in a corner. Forward slowly to the other end of the house. As you progress, spray the jet of water at the bottom of the house and climb up to the evening rooftop. Always work from the bottom up, this reduces the risk of streaking. Be sure to saturate every inch of the page you are working on.

If you do not, you have points where bleach and detergent did not touch. When you get to the end of the house, remove the 'downflow' hose from the bucket to the cleaning solution and return to the side of the house again, this time with only clean water coming out of the hose. Rinse the coating thoroughly. Now I should be done with that side of the house. Replace the 'low transmission' housing in the resolution drawer and start the next side of the housing.

You need to get close to the wall to get the solution in every inch of the coating. If you get too close, a good amount of spray falls on your head, so don't get too close. Be careful not to spray in open areas and get water inside the house. Also, be careful not to spray windows if the pressure is too high. Never go up a ladder to reach high places. It is very dangerous to work with a high-pressure cleaner and try to balance on a ladder. Remember, this is an extremely high pressure, so never point the nozzle at anyone and make sure you wear safety glasses. Of course, never spray water around electrical wires.

Pressure Washing

Related Article